Electro Aire F858-1002 Power Supply
List Price: $491.82 Sale Price: $345.00
Electro Air F858-1002 Power Supply. Replacement high voltage circuit board kit. Includes air flow switch, LED, instructions, retrofit hardware and power supply. This kit replaces the following power supplys F858-0216, F858-0238, F858-0303, F858-0368, F858-0369, F858-0405, F858-0414, F858-0415, F858-0448, F858-0488, F858-0574, F858-0585, F858-0622, F858-0705, F858-0706, F858-0707, F858-0708, F858-0903, F858-0912, F858-1000, F858-1001, and 3370D.
NOTE: Obsolete and only available while supply lasts.
Electro Aire F858-1002 Power Supply by Dwight Jarboe (Coshocton Oh US)
Kit was complete and in good condition. Installation was straightforward and easily accomplished. The air cleaner was restored to normal operation.
"Electro Aire F858-1002 Power Supply by Mark Lobo ( Ne US)
Outstanding. Fits like a glove. Very straight foward. Works like a Charm.
Great Fix by (Monroe NJ US)
After finding the power supply was bad and locating the model number on the front of the Sears unit the replacement part fit like a glove. The only concern is that the air flow sensor was a little short but it seems to working ok.
I can fix it with the right parts by Erick rigby (Bluffton IN US)
Just what Lennox said I could not get any more. Took 10 minutes to make the rapir.
Home Owner by Michael Davison (Fallsington Pa US)
Parts fit and work great. Only time will tell Thank you
Electronic air filter PS by Paul Nimz (Ashkum IL US)
The power supply (PS) went out on my old Sears Electronic Air Cleaner. I was easy to find a replacement kit with the online chat help and had the product in a week, Install was straight forward and the instructions were complete.
Easy and Works by Kris Aasmo (Sterling VA US)
I installed the power supply (my unit does not have an air-flow switch) in about 15 minutes. Disconnected 5 wires and the ground wire... remove the old power supply... put in the new one and hook up the old wires and voila! Installed it and it works like a charm.
Pleased with results by Todd McBride (Plum PA US)
This was the first one ever I worked on. New parts are well built and considerably beefier than old power supply. Had to bend housing retainer clip back 1/8 inch and alignment clip back 1/16 to get new power supply to fit(results good). The metal protection clip over the new air flow sensor has to be removed before it will fit through the opening(took me a few minutes to realize) Very pleased with final outcome.